Posted by Zsprankle on September 04, 2022 at 18:42:28 from (71.60.32.187):
In Reply to: Farmall c knocking? posted by Zsprankle on September 02, 2022 at 18:26:35:
Thanks guys, I've considered all of your replies, truth is, I don't idle it down like that normally but it does make this noise when I shut it down, because I'm familiar with engines it drives me nuts, can't be valve train noise, I adjusted the valves roughly 100 hours ago and there was nothing like that before, plus when you put your ear up to it the sound comes from the bottom end, hydraulics don't make a difference and putting the engine under load makes the noise go away( I think it may possibly be still there but not as loud). When I rolled the bearings in I had my machinist dad measure the crank at the rod journals, (as you can't get to the main journals accurately with the crank in) and the measured within spec( don't remember as it has been a while) but all the journals plastigauged just fine, and I will have to try removing one plug wire at a time but I know the noise does come from all 4, thanks for all the input, I was thinking really seriously abojt tearing it back down this winter but an not thinking so hard about it
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
