I have used lucas hyd conditioner and sealant a couple of times with moderate success. I have a couple of ih3588's with alot of hyd leaks. Put a couple of gallons in each and seemed to dry up alot of the smaller anoying leaks. didn't stop anything major. But more to your problem, I have a cih 1594. 3 sp gear box with 4 sp power shift. Power shift 1 and 2 were fine but it got so it wouldn't always go into 3 and 4 . Would go into those gears but not solidly. would move but slip under any load. Sometimes would shift solidly after running it awhile. Runs a discbine. last fall got so it wouldn't go into 3 and 4 at all. Talking to mechcanics, they suspect that the clutch pack seals are leaking. What did i have to lose. Put about 5 qts of the lucas in it. Didn't totaly cure the problem , but has been very usable this summer. Sometimes it shifts properly right away, and sometimes have to run it awhile. So it looks like thats where you are at. What have you got to lose?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
