Posted by BarnyardEngineering on September 21, 2022 at 04:55:35 from (161.69.123.10):
In Reply to: 1855 ? Oliver V8 posted by jm. on September 20, 2022 at 17:53:52:
It wouldn't have been 18 because those have the Waukesha straight 6, not a V8.
It surprises me how the same basic group of guys get all bent out of shape about a guy wanting to perform a science experiment on a Farmall H engine block, which they made 500,000 of, but scream "JUNK IT JUNK IT JUNK IT!" when presented with a relatively rare tractor, not knowing if there is even anything wrong with it.
Rust sands off. Rims tires and seat are easily replaced.
If it's just for a collection, it doesn't even have to run. Huge plus if it does, but it's not a requirement. Heck it probably will run. You don't need a freshly rebuilt engine for it to sit in a barn.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
