I use a couple different patches and boots along with some valve stems that all glue on. I have used Black Jack and Tech. I prefer Tech they have a bigger supply of patches and they have a couple different glues for their patches. I gleaned this off their website the other day. I'm sort of in the same boat as you are. Big problem is they want to cater to the tire shops and don't care much about the individual. I'm trying to find a tire place using the Tech stuff I could order things through then be able to get what I need for things. Buying the onesy twoesy thing don't work for me. I need more supply with more variety for patching things I need some patches suitable for a nail hole then something for a bigger hole and then bots for the tires as well as some plug patches and air water valve stems for rear tractor tubes . I hate to throw tubes out just because the rubber pulls loose from the pipe at the stem and the rest of the tube is still in fine shape with no patches on it. With probably close to 300 tires around I can't run to a store for each tire job and on Sunday night I need them at the house. I'm going to talk to another guy I found out uses Tech patches and see if I can work some kind of a program with him for them. I can order some of the patches online with some reason able quantity just not wanting to have a box of 10 air water valves on hand at about a 100.00 for them and have them go bad over 20 years. I have not yet lookeed at Camel or Milton for pieces yet.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
