Posted by jd2cyl1943 on November 08, 2022 at 16:04:37 from (68.235.109.18):
In Reply to: Dain all wheel drive posted by jd2cyl1943 on November 07, 2022 at 18:52:56:
Sure!
The Waterloo boy R was getting old and JD wanted to build a new and easier to handle tractor. So the designers hit the drawing boards. That was about 1915 I believe. It was built in 1917. It incorporated a lot of the features that the later Two-Cylinders would continue for years. A lot of the working parts were out exposed to the dust and Rainn so a cover had to be fabricated. This cover become known as the "bathtub cover" around the company, which led to its name of the Bathtub D. Actually, its bears little resemblance to the D. It looked more like a Waterloo Boy and actually used the Waterloo Boy name on the radiator. It used a Waterloo Boy R 2 Cylinder engine, and a steering system. In 1992 in Waterloo during a construction project the crew thought that they found a D main case, and Earl Scott bought it. Earl never had time to work on it and in 2011 sold it to Dan Thomas. Earl told Thomas that a number of pieces of scrap iron were stolen of his property , and the main case was dragged out and left behind because it weighed too much. Over the next 6 years the Bathtub D under went a full restation to the state that it is today. The rest is history.
I cant figure out how to post a link, but here is the a video you can copy and paste into your search bar.
https://youtube/2vTbR7s9suw
This post was edited by jd2cyl1943 on 11/08/2022 at 04:08 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.