I played with my mom's years ago. It's not the easiest to get the hang of, but I did like the challenge. It's still at the house here & at some point it will go in for a servicing. Then I'll have to try it out. Accordion music is a favorite of mine. There wasn't a wedding reception on my mom's side of the family that didn't have 50/50 polka & '50s rock 'n' roll played at it. It's also good milking parlor music. To top it all off, my favorite polkas are nearing the century mark. There were so many different sounds that represented the old world European countries to set them all apart. A polka from Germany does not sound the same as one from Austria. One from Lithuania does not sound like one from Poland. It's the same basic sound, yes, but all with different flavors. And, as with everything.... it seems to have gotten lost somewhere in time.
The videos I'll be posting will have a mix of older polkas & some early country. I must be careful though. I can get git hard with a copyright strike & get my channel suspended. Right now, the video has a copyright claim. There's a message that says, The Content ID claim on your video doesn't affect your channel. This is not a copyright strike. Far as I can tell, it means whoever owns the rights to that song can monetize my video & I do not get into trouble posting it. However, those of who that monetize their channel would be unable to do so with a song like that in it. So, with me it's a non-issue. Just have to be careful & stay away from pop music from any point in recorded history.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
