Posted by miangus on December 14, 2022 at 09:00:44 from (136.181.197.68):
In Reply to: Electrical posted by rlp in Co. on December 13, 2022 at 14:20:26:
The key is the two circuits always had a combined voltage of 240 volts, they are feed from different legs. Loss of the neutral reference at the neutral bar results in the circuits sharing the 240 volts based on circuit resistance. Now if the circuits were on the same leg, loss of the neutral connection would just result in a dead circuit. I would carefully inspect the system to ensure that loss of the connection didn't occur somewhere else in the neutral connections. Remember the same guy probably did all the work.
As to your furnace, I have discovered that most if not all solid-state devices are protected by a solid-state switch installed between the neutral and the hot wire. This switch when exposed to high voltage closes parentally and coupled with a fuse system in the circuit disables the device to prevent overheating. Sometimes you can locate this switch and replace it and the fuse system.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.