Posted by Dwest37 on December 16, 2022 at 17:47:12 from (98.159.188.7):
Quoting Removed, click Modern View to see
Hello, old topic i see but im in the exact same situation and am wondering if your issue was ever resolved?
I have a Dx130 with a new clutch that worked fine and it is now slipping in anything over low gear, i took off the clutch side cover under the ladder and can see in, the clutch doesnt look too worn from what i could tell.
Is the powermatic engaged by oil pressure like the Oliver/White tractor over and direct drive was? It almost seemed like it slipped and as i revved it higher during the slip it caught more as if it built oil pressure and grabbed better.
So far the best idea i have is to paint that area of the clutch i can see and run a jumper from starter to the cab so i can start it in gear and cause the slip, then line that paint area back up and see if the clutch disk slipped in the pressure plate to eliminate one of the 2 possibilities.
Thanks in advance for any help or ideas someone may have!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
