Posted by redforlife on December 28, 2022 at 22:16:25 from (174.210.164.188):
In Reply to: Insulated overalls posted by TimWafer on December 28, 2022 at 12:31:28:
I prefer bibs that zip down in the middle of the front bib. And also have leg zippers that go all the way up to the hip, and not just up to the knee. With those zipper preferences, your kind of limited on brands. Some brands don't put zippers in like that. No zipper in the bib. Or only up to the knee in the leg. As much as I take mine off and on, I really watch for that. I walk away from some brands because of that reason.
I also like the slit in the side so you can get your hand into your jeans pocket underneath. Some brands don't put those in. Only a pocket whole for the pockets that's in the bid overhauls themselves. I can't stand not getting into my jeans pockets without taking the bibs off.
As far as zipper quality, about all I can tell ya on that, is just pay attention to that when your shopping.
Another tip is, during this time of year, selection in stores gets pretty picked over. They might have a whole rack of extra extra large, but not one pair in your size (been my experience). About got to hit the stores in the fall to find a pair that fits right. Especially if you where a common size.
All and all, I haven't really had any bad luck with zippers. I guess I might just be hard enough on the material, that the bibs just don't outlast the zippers. About 2 or 3 years is about all I get out of mine. Tough material or not. But, ... I do cattle chores in them every day. So they see some tough use.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
