Posted by IndyFarmBoy on December 31, 2022 at 21:06:02 from (107.77.234.135):
Ah the Pug. Roughest and toughest utv out there. Unless its got a Harbor Freight engine. . .
Hey y'all, so I have this Pug Badlands, I think its an 80s model but I honestly don't know. And when purchased, lets just say that it was heavily customized . . .it has the gondola style bed, the 4 speed Escort trans and the round/square style headlights (if that makes any sense). I know it originally had a Kohler V-twin but it didn't come with it. Does anybody know the model of the original engine that woulda been in this unit? I either want to find one of the original engine models or I would use the model to find out what model EFI Vanguard I could swap in. Also, I know that later on in the manufacturing they switched to the 5 speed trans, does anyone know if the 5 speed was an improvement? specifically if 1st gear is a higher ratio on the 5 speed? 1st gear on our 4 speed is just a little too fast, I'd love a slower gear. Thanks for any information y'all can provide on this rare bird.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
