Posted by Hobo,NC on January 14, 2023 at 06:09:47 from (75.137.54.252):
In Reply to: champion spark plugs posted by rustred on January 13, 2023 at 16:32:10:
Cool.
When I think I am going after an electric fuel pump on a vehicle with a metal tank I ask the big question. "If i see any rust it needs a tank are you going to OK a new fuel tank" That also includes a mechanical pump engine that I am replacing the fuel sender are anytime I drop a metal tank for any reason.
If they say NO I decline the job : )
I just replaced the tank on a 88 ford F100 it surprised me the inside of the tank looked great. I cleaned the top side where it had an insulator pad between the frame and the tank. After I knocked off the rust it had pin holes.
I do like plastic tanks I plan to put a set of plastic tanks on my 95 F250. I put a new set of metal tanks on it 5 years ago. One of the sender floats got a pin hole in it I had to replace the float. The inside of that new tank looked to have some rust in it. When i service it soon, if I see any rust in the fuel filter I will order those plastic tanks.
Good clean fuel is hard to beat : )
This post was edited by Hobo,NC on 01/14/2023 at 06:10 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
