It's not critically important which type you get. It's an old JD 2-cylinder, not a race engine. Any hone is better than no hone. If you have a cheap 3-stone hone that fits, use it. If someone you know has a fancy dingle-ball hone that you can borrow, borrow it.
If you have to buy one, normally I would recommend the Harbor Freight hone but it only goes to 4" while the JD B's bore is 4.6875"/4-11/16". Amazon has a good selection of inexpensive hones with up to a 5" capacity if you need to order one.
Now maybe it's just me but I didn't take Bob Harvey's comment as mean-spirited. By the time he responded your question had been answered six times over. So he made a simple smart-azz remark to have a little fun. No reason to get upset.
There are far more means-spirited people on this forum who are celebrated for their "years of experience" and defended ferociously if called out on their shenanigans.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Modern Diesel Fuel in an Old Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.