Posted by the tractor vet on January 26, 2023 at 10:47:46 from (108.220.145.239):
In Reply to: On Woody 7902, 806 posted by fastfarmall on January 25, 2023 at 12:40:13:
The IDPTO input shaft and the pressure plate will ware more on some then others , this depends on what all you do . Tractors used primarily for tillage and not heavy PTO work last a lot longer Like on mine i have had that ugly 806now since something like back in 94-95 and so far we have put in two clutches , one due to pulling the center out of the disc and at that time i did replace the IDPTO input as it was well woren . Then i did replace it when it went out from all the PTO work it does as it has become the go to for all the hay mowing and all the feed grinding plus brush hogging some manure hauling and spray tractor . They never seam to ware out when they are setting . Once the weather breaks i have the 1066 to do and come to think of it this is the third one on it , It does all the silage choppen and some feed grinding when the 806 is hooked to something . stop and think about it a bit and it is a wonder they last as long as they do being a dry spline running in a high dust area from clutch dust and the grindings off the flywheel and the light rust from seeting then back to running and wearing the rust off .
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
