Posted by thehickdaddy on February 01, 2023 at 12:11:22 from (50.38.89.140):
In Reply to: Moving Brush posted by TomIn on February 01, 2023 at 03:31:45:
as double07 posted below, rear mounted 3 point brushforks are very common in the orchards here in pacific NW. with the weight on the rear, the traction is where you need it as well as stability. the photos below are of the brush fork my dad built in 1960s and is still very well used to this day. as you can see, the headboard and tines are all bolted on for when the blade is used for snow and gravel and dirt or any other tasks during the year. and with the length of the blade frame, the brush can be stacked in decent piles. the previous method of moving tree and cane berry trimmings was tossing onto a flat bed trailer by hand, driving to edge of orchard or canyon or burnpile, and hand unloading. requiring at least a tractor driver and one or two throwers. at this time, the family was renting approximately 100 acres of nuts. and with trees planted 20 foot square from each other, made for an average of 100 trees per acre. that was alot of hand work every year of clearing out the limbs after the hard job of tree trimming. Dad says he can not guess how much faster the operation became with the brush fork. Dad said just traveling thru the orchard with a solo tractor instead of tractor and trailer was faster, and the work completed much faster, and you could start the brush fire and keep feeding the fire with each brush pile instead of tossing in one limb at a time without getting smoke or ash in your eyes. brush fork is on Ferguson TO30 with sherman 3 speed in overdrive. dad said he was very proud of the outfit and it really worked great. Plus he said it was at a time when most front end loader tractors were much too tall to fit the the orchards safely, and if they did fit down the rows, they were tippy and dangerous on the the many hillsides.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
