Posted by Geo-TH,In on February 14, 2023 at 04:30:06 from (65.189.196.95):
In Reply to: Starter problems posted by 8NHENRY on February 14, 2023 at 03:12:17:
Some here won't agree with what I'm about to say, but it's true. Both my Jubilee and Farmall C have rebuilt engines with good compression. Both tractors were converted to 12v. After shearing off 2 starter drives on each tractor, I replaced my Jubilee's starter with a 12v starter. It not only damaged the starter drive, it sheared off a tooth on the starter ring. No 12v starter available for my Farmall so I replaced the 12v battery with my oldest lawn mower battery and used 10g wire instead of battery cables. End of damaging starter drives and chipping off starter ring teeth. I'm only able to do this because the Farmall has a magneto and produces a hit spark.
So if you have converted to 12v and have a rebuilt engine, be ready to replace a lot of starter drives and teeth in the winter.
I used a magnet and fished out many pieces of broken starter drives out of my Jubilee's bellhousing.
Is your starter a 6v starter and you converted to 12v?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
