Posted by Deerediesel on February 28, 2023 at 17:46:50 from (107.77.215.69):
I ve searched the forums quite a bit and haven t found my answer this question is for those of you that have put a 619 in a 6030. Almost everything has went together pretty easy. M wanting to know what the rest of you did with the air cleaner assembly?? The 619 exhaust manifold sits 2.5" higher then the 531 manifold. Spacing up the air cleaner housing is easy. My issue is the pre cleaner mount that bolts on top of exhaust elbow. It now sets above where the hood will be .I m already planning on lowering the two holes in air cleaner housing , and doing what ever I need to do to the pre cleaner mount .. but I do not want to cut a hole in my hood. I ve found a few pics of 6030 s on the net with 619 s.. it s obvious when you see the air cleaner housing sticking up..but none of them have any hood mods any info or suggestions would be appreciated.. thanks
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
