Posted by Grateful4Knowledge on March 08, 2023 at 22:06:07 from (107.77.201.141):
Humbly seeking knowledge.
Help a farmer out, if you have experience replies are appreciated.
Ford 8530 specifications of original
Flywheel Thickness on a 8530 Ford
tractor.
This project tractor had the flywheel trimmed down previously, by alf an inch, during the final stages of repairs but then clutch keeps pulling the tractor instead of not pulling when we put the clutch in. For repair /parts time efficiency it would be a boon if anyone knew the original thickness of the flywheel from previous measurements or calipers. Various sites, parts stores, tractor manuals havens listed the actual thickness of he flywheel that I ve found.
If it s an 1 1/2inch thickness or otherwise originally it s a mystery as compared to the thickness now.[/code]
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
