I am in michigan and help the owner of the camp where we camp. He has a 50 horse international loader tractor. Saying an early 2000 model. The camp is 100 sites that is on 2 different plains as ground goes. The tractor is great for him. He uses the loader to deliver camp wood to sites as in the state most camp grounds dont allow incoming wood do to ash borer. It is right size to charge a $30 charge. Loader also moves sand or dirt around to sites that have a soft sand base or with a hitch ball mounted can move a camper around after a patron gets truck or trailer hung up. The tractor has enough power to pull the vac box trailer for leaves branches ect that happens beginning of season. Also runs the honey wagon after weekends when seasonals want their campers pumped out. I agree with having someone in to clear sites. Most of the newer loader scraper systems have a level systems. when your clearing sites that would be so well used. When a site isnt level it mostly leads to having leveling material handy. cause people seem to not think of that or tools to move dirt to make it level. Our guy was looking at the skid steer but they are quite expensive. He did get his self a Polaris Ranger with blade attachment. Uses that to chase stuff or do light work. But it also is useful locally as there are many trails managed by govern agencies. He leads many trail rides for those with bikes sidebysides and quads. These are just things I have helped use machines for that some may not think of. Hope it helps.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
