Posted by redforlife on April 16, 2023 at 14:58:56 from (68.234.121.189):
In Reply to: Pondering spray Guns posted by jd2cyl1943 on April 16, 2023 at 13:21:55:
I painted a couple tractors when I was in high school. I had never painted (spray gun style) before, and knew nothing about automotive/tractor paint. But, ... I stumbled my way through it, and learned as I went along. I ended up with basically a descent looking paint job on the two tractors. But I kind of wished after the fact, that I would of just let somebody who actually knew what they was doing help me out with choosing the supplies, and actually let them spray the paint using thier experience. I didn't use any paint hardners or give it a clear coat. And I seen alot of other people's paint jobs afterwards that looked really superb and almost like the paint was still wet. My paint jobs didn't turn out like that, but maybe they would of if I had somebody with experience involved. That was before the days of internet, so I didn't even have this.
Anyways, you might want to do all your own prep, primering, and sanding and what not. And let somebody else (in person) help you with the actual paint and choosing the right primer for the kind of paint your gonna use. If nothing else, as a on site coach. There is tricks to painting. Some tricks that you will unlikely learn on your own. But can be learned from somebody else. Might make a big improvement to the finished paint job.
Maybe your not particular with how it turns out. And just want paint on it. And that's fine too. And maybe your short on resources. But I wouldn't short myself on atleast having a coach involved. You said your dad knows somebody. And maybe there is somebody else. Even if they just coach from the sideline, they can save you alot of learning as you go, when it comes to paint.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.