Posted by Hobo,NC on April 19, 2023 at 04:06:10 from (35.148.144.137):
In Reply to: Rock Auto question posted by Leroy on April 18, 2023 at 11:17:17:
Quote: CVPost-Leroy (quoted from post at 06:20:00 04/19/23) The rotor wore so thin the caliper poped apart. Blew out and all fluid came out. And I am not looking for long term warenty as I figure if I get 5-7,000 mile yet out of the truck it will be in scrap yard at that time. And so far I found rotors at a junk yard for $130.75 and the truck is not worth those prices. Orileys rotor priced at $94.99They came up with total price for pads rear rotators and calipers at $1.427.33. I cannot afford that on a truck that I could only seel for salvage price.
Using the info you gave, at Advance auto
Decent set of brake pads not elcheapo $45, I never look at the cheap pads. There Gold pad has served me well
Rotor $80
Caliper $55
Both sides $315 if you order online you get 15% off. Free pick up in store.
ECM, you are on your own I would not supply one for a customer you buy it you deal with it.
This post was edited by Hobo,NC on 04/19/2023 at 04:07 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
