Posted by redforlife on April 28, 2023 at 20:22:37 from (174.213.209.98):
In Reply to: Tire Removal posted by jd2cyl1943 on April 28, 2023 at 19:27:39:
Lay tire and rim down on the ground. Lay the right size/length of plank board upon the tire (but not on the rim) as if it were a ramp. Drive another vehicle up on the board to bust the bead loose. Work your way around the wheel, and then flip over and do the same to the other side.
I use a 3X12 plank however long. The longer the better. If tire goes down but don't bust the bead loose, I just move to a different spot or add a short piece of 2X4 between the plank and tire to get you a little more down action.
Not the best way of breaking a bead loose, but works if you don't have the proper tools.
Once the bead is broke loose, just pry the side wall off with pry bars.
I prefer this way better than grinding and sawing, but I have done it that way too. I used a cutting torch one time too. But that's something I won't do again. Rubber just catches fire, and gets real real messy.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.