Posted by andy r on April 28, 2023 at 21:50:09 from (208.126.193.44):
In Reply to: Tire Removal posted by jd2cyl1943 on April 28, 2023 at 19:27:39:
I have been using a handy man jack. I always keep the tire/rim on the tractor. Put the foot of the jack parallel to the rim on the tire bead. Run a decent size log chain around the tire and rim and hook it into a circle. Obviously the jacks lifting point is hooked under the chain. Start jacking. May have to steady or hold up the end of the jack. Probably best done with two people although I use this process myself all of the time. This is the best thing I have found to break tractor tire beads without buying the the hydraulic or screw type bead breaker. I have a screw type bead breaker which really doesn't work all that well. As you are jacking allow time for the tire to begin moving. Liquid soap or WD40 helps lubicate things. Push back in one place and then you might have to move a foot or so and do it again. Once the front side is off do the same to the back side. Most of the time I do not chain the back side. I still put the base of the jack on the tire, but push off of the drawbar with the lifting point of the jack. It is important that the foot of the jack be as close to the rim as possible. Pushing in the middle of the sidewall does nothing. Anytime you use a handy man jack take precautions, but I have never thought of this useage being all that dangerous compared to other tire bead breaking methods.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.