If it is screwed in the bottoms of the corrugations or on the flats it never will seal and not leak. If it is corrugated I would remove the screws and flip the sheets over so the holes are on top then screw it back down with some 2 inch screws into 2 inch wood. That will solve that. I was talking to the owner one time and he said nobody around there which is Greenfield IN screwed steel on the top of the bump. And as we compared notes he found nobody up my way MI screwed steel on the flats always on the top of the rib or they leak. We concluded the snow as it melts and slushes on the roof holds enough water to seep in by the screws on the flats being the reason for being on the top of the rib. They also make a tape for the lap joints that goes ton the top of the first rib then the next sheet goes down ontop of the tape so it works like a gasket sort of so water doesn't run over the rib/bump at the lap joint. We also get 24 gauge steel for the material on our roofs there. The only place I know of that we can get it that heavy and will run at least 40 foot sheets in one piece. He said they could go longer if ordered.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.