Hello will welcome to YT! Not sure how much you researched the All Crop machine or what you know about the operation of combines. The AC combine will do a very good job at harvesting the crops you have mentioned. But as another poster mentioned finding one that will reliably operate to do your harvesting year to year will likely prove difficult. Your question about using it to swath hay shows that you may not be 100 percent in tune with the operation and function of a combine. Look at the video in the link at 1:45 to 2:45. There it is showing you how the threshing cylinder smashes and rolls the crop as it come through that initial portion of the threshing process. This is not something you want a hay crop to be subjected to. You can open the gap the crop is forced through but even at that it will still be exposed to plenty of damage. Beside this having all the parts of the machine rattling and clanking along not functioning as intended while you ..swath.. your hay will place undo wear on the machine. That is the same machine that you hope to be reliable while you are trying to harvest your grain crop. You already have a sickle mower you just need a rake. Tons and tons of hay were put up to feed animals with a sickle mower and rake before swathers became widely used machines.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
