Posted by paul on May 15, 2023 at 07:49:02 from (66.60.209.84):
In Reply to: Rear Duals posted by coleman251 on May 15, 2023 at 06:53:11:
Leave the dual wheels empty, just air. As you turn your tires need to give some, the outer wheel needs to travel farther than the inner wheel. You dont want them all filled too much stress.
For plowing you only want the left dual on. You need to remove the right dual to be in the furrow. Often here the wheel in the furrow gets good traction and the wheel on the left will slip or spin some on frozen or wet ground, so that dual can help - but it is up in the air a bit so its not a world changing thing.
Larger tractors with plows of 6 or more bottoms can be one land and the tractor does not drive in the furrow but all on land. Those you can use duals on both sides. There many be a few 5 bottom on land plows, but really not wide enough to use the right dual anyhow.
Everything else duals can help you out with disking, field cultivating, chiseling. A bit smoother ride, better traction.
The duals often are a tad smaller (just used worn down a bit) and have a bit less air pressure, set up to be secondary, or a bit less traction than your main wheels. As I said they have to scuff a bit on turns, and being out farther they put more pressure on your axles. You want the duals as helpers, not as the main wheels if you know what Im trying to say.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.