Posted by mdeisenhauer on May 21, 2023 at 08:13:54 from (135.26.70.130):
I have an old 4010. It was running good with no real issues for a while now, then about 3 hours into some work it started to lose power and died on me. At that time I didn't have an opportunity to address the issue. I came back to it a few days later and noticed the fuel filters were not full. So I manually pumped the lift pump to fill the bottom, then the top filter, then cracked the supply to the injection pump and primed until all bubbles were removed. After a small bit of cranking it fires right up and ran for 20 mins before doing exactly the same thing from the first instance. It started to lose power and then died. I repeated the steps above and got it to run again, and again it started to lose power and died. I did this a few more times and always the same result. Yesterday I removed the fuel supply to the lift pump (plenty of unrestricted flow), removed the filters and blew through the ports, checked the return to tank line and that was clear. I'm at a loss at what it could be. Anyone have any recommendations I should investigate?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
