If you're talking about the usual sense, I worked out of a home office for 10 years while I was doing real estate inspections.
The company I worked for was headquartered in Cleveland, Ohio, my District Manager was in Minneapolis, MN, and I was here in Nebraska doing what my computer told me to do. Inspections to be done were posted on my computer, reports were submitted online, etc. I'd spend a couple of days on the road doing inspections, and then spend a day or so in my home office doing reports and other paperwork. My sole contact with the company was by computer. I only met my District Manager and other company executives a few times at seminars and training sessions.
It was OK when I started and my wife was still working. I had the house to myself when I worked in my office. After she retired, she drove me nuts. She never had a job that required her to use a computer on the job, so she didn't look at working at a computer as actually 'working'. I could be totally wrapped up on my computer trying to get a footprint of a building worked out, or something similar, and she would walk into my office, plop down in a chair, and start talking about remodeling one of the bathrooms, or something.
But, I survived, although working from home is not for everyone.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.