The oil bath filter is better than and cartrige filter made. It just takes a bit of time and knolage about them. If you are working in VERRY VERRY dirty conditiond like where you cannot breath any air in your knse than pull the bottom of at end of day and take your finger and use it to see if any dirt on bottom under the oil. It was recemonded by manufactor to do that mut highly unessary. They if there was a 64 inch of dirt recemonded cleaning out and throwing old oil out, nessary or bright idea NO As lomg as dirt does not build up in bottom of canister forget it, and even if very dirty conditions once a week to check only and possibly once a nonth to drain oil out and clean bottom of canistor and you can evem put the old oil back with just adding a couple of tablespoods to bring it up to leve; And the tractor that has been with me for 79 years never got water in the canister. And the one that is 3 years older than me has never that I ever knew got water in there. It just takes a little thought about what you are doing instead of just yanking a good paper filter out and putting a lot pf dollars in. DO NOT EVEN consider getting rid of that oil bath. And my newest tractor a 1941 Ford (n came to be with me when I was 9 months old and the older one is a Ford 3 years older than me. As long as I am living they will never changed on the oil bah filter, the orignal oil filter, the 6 volt system that inclufs no electronic ignitation. I would not buy a tractor that was messed up with that stuff.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
