Quote: CVPost-FergusonTO20 (quoted from post at 11:38:48 06/28/23) I bought a brush hog for my Fergusion TO-20 about 25 years ago and used it every year to clear about five acres of grass for firebreaks around my 40 acres of land. It worked fine all that time. However, one year a retaining pin fell out (I should have inspected it every year), the drive shaft eventually worked its way off the splines, and the drive shaft ended up bouncing around wildly as the blades continued to spin. That bent the drive shaft and so it was time for a new drive shaft. A few hundred dollars later, I had my brand new drive shaft. It came equipped with a snazzy black plastic cover with two bright yellow skirts on either end to partially cover the joints.
I didn't see any point to those yellow skirts; I assumed that they serve to keep dirt and straw off the joints. But then they came loose and they do NOT want to be properly reconnected; the retaining snaps refuse to snap in.. So now I'm wondering if they're really any good. They make it harder to grease the drive shaft or the joints. I am sorely tempted to cut them off.
So, can anybody tell me what the function of those yellow skirts might be, and whether they're worth keeping in place?
It should be obvious that that shielding including the belled ends are to cover exposed rotating parts to keep clothing or anything else that could get caught up in the spinning shaft away, preventing a human tragedy or mechanical damage.
While the belled ends don't 100% prevent such a thing, they are better than nothing!
This post was edited by wore out on 06/28/2023 at 12:09 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.