[quote="CVPost-used red MN"](quoted from post at 00:17:23 07/01/23) Hello Chop welcome to YT! It seems you bought a rare
tractor capable of reverse psychology. Maybe more
like it is capable of reverse roles which all in all is not
that uncommon. What I mean is you probably had
intentions of working the tractor, instead the tractor is
going to work you. I am no expert on your particular
machine but know enough to have a pretty good idea
of what you have going on. The plate covers a cavity in
the tractor that is what is referred to as a dry cavity.
No oil should be in there, see link section 03-
Transmission, subsection 07U01 part 3. The area is the
location for the torque converter to sit and spin in. Is
the oil leaking black? If so then it is engine oil from the
rear main crankshaft seal. If this is what you find I
would check the engine oil for being overfull. If it is it is
likely that your injection pump is leaking fuel into the
engine oil causing it to overfill. There is a possibility of
correcting that problem and keeping the engine oil at
the proper level may fix that leak. Secondly, if the fluid
leaking is more clear hydraulic fluid used in the
transmission, then it is coming from
the torque converter seal or other items on the front of
the transmission. Again in section 03, subsection
07U02, I believe there are mislabeled parts in the
diagram, 56 should be the seal. For whatever reason
the orientation of the parts in this 2nd diagram is
opposite of how they actually fit in the housing per the orientation of it in the diagram.
Unfortunately, replacing that seal or the engine rear
main seal requires splitting the tractor. Did the party
selling the tractor overlook telling you about this
problem? Maybe it was bought through an online
auction?
Thank you for advice .
After re inspection , nothing come from the transmission seal. My power steering is way too loose and the hydraulic leak is located exactly over where the missing plate is .
So now what are the possibilities ... Will have to investigate to find the root cause.
Best regards and thank you for your piece of advice
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
