Well, if we're complaining about bad intersections...there's three or four around here I can think of. At one the old lady on the corner has planters, flowers, gnome statues, etc. right up to the edge of the road. Got to have half your car in the road before you can see if there's any oncoming traffic. At another the guy has a fence and shrubberies, same thing, only it's a lot busier road and they really fly through there. Been a couple pile-ups and he still hasn't been made to take it down or move it back a little ways. I don't understand it? There was an old farmer that used to plant his garden right up to the edge of the road. He only planted short crops, cabbage, lettuce, pumpkins pickles; well, the road crews must of hated the guy as they would mow his garden when doing the road sides. I seen them do it over and over for 15-20 years, until he passed. Just not right.
The new wrinkle around here is some folks like to ride their pedal bikes right down the middle of the road. Supposed to be safer? easier to see? This one gal was riding in the middle when I came up from behind. It was on an uphill and I couldn't see if there were any cars coming so I had to slow down to her speed and she was slowing down further because of the hill. I tooted my horn as nice as I could, and she looked back then made a gesture for me to go around. The thing is there was no way for her to see over the hill yet either! I gotten behind her several times now and am seriously thinking of dropping a dime on her to the county boys. I believe in sharing the road, but that goes both ways.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
