Posted by INCase on July 17, 2023 at 06:02:35 from (209.221.240.192):
Hello,
when we bought my wife's grandfathers tractor the PTO shift lever was cobbled up. from what i can tell, basically someone (hired mechanic i'm sure) clamped a plate to the shaft with a u-bolt and welded the lever to the plate. the weld broke yesterday while testing the new brush hog. luckily that lever is really easy to move so i just grabbed the plate and put it in gear.
I've seen 2 or 3 different levers for that tractor. it is a 1968. i have a picture of what i have, if i can find it, i'll post it.
questions: 1, what lever is supposed to be on it? was their more than 1 type of PTO setup for those tractors? this one has the 2 stage clucth pedal. all the way down is PTO, most of the way down is transmission.
2, i see some include the shaft, how hard is it to change the whole shaft and lever assembly (how most appear online as 1 unit). Do you have to take the top cover off the transmission?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
