Posted by MARK ROBKE on July 29, 2023 at 09:08:18 from (75.90.200.24):
In Reply to: Glyphosate posted by john in la on July 29, 2023 at 05:25:05:
As I understand the label, I mix 4-6 oz per gallon in a spot sprayer, either the 2 gallon hand sprayer or the 10 gallon electric one. Using too weak of a mixture causes resistance. I now mostly spray my gravel driveway and not much else. Glyphosate is only supposed to be absorbed by green foliage, and weeds with mostly stalks have a harder time being killed by it. However, over time repeated spraying will cause bare dirt which can erode and become a place for more weed seed to germinate. Catch-22! Other desirable plants may be an alternative after spraying. It takes about a week for most stuff to die, but good grass is a little quicker to die. And it can drift a foot or two if you are not careful. Pramitol is supposed to prevent seed from germinating for a season, but I have had mixed results and you need a rain shortly after spraying it, and it can leach to areas where you don't want things to die. Mark.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
