Posted by John T on August 16, 2023 at 15:47:57 from (45.16.200.171):
In Reply to: 12 volt conversion posted by tomturkey on August 16, 2023 at 14:30:48:
Hi Tom, your good question:
If that is the case does one need a 12 volt coil in the conversion, and if you use the existing 6volt coil do you need a resistor. Any explanation needs to be simple and straight forward
its been answered before by myself and others so I will just give you some basics, SIMPLE AND STRAIGHT FORWARD AS YOU ASKED and ONLY to your question
If its a 12 volt tractor you can use EITHER A) A full true 12 volt rated coil NO BALLAST REQUIRED orrrrrrrrrr B) The old 6 volt coil PLUS an inline series voltage dropping (12 down to 6) Ballast Resistor placed between the ignition switch output and coils input (NOT elsewhere is my choice) .. That way it drops 6 volts leaving 6 volts for a 6 volt coil EASY PEASEY works either way.
NOTE match the coil polarity to that of the tractor.
Hey this YOUR tractor YOUR money YOUR choice you get no argument from me
Post back any more questions, I purposely DID NOT talk about things you didn't ask.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
