Posted by Janicholson on August 31, 2023 at 19:07:20 from (24.240.46.228):
In Reply to: Barn Question posted by Joel Cassell on August 31, 2023 at 18:16:58:
If the yellow eroded foundation is a mortar like material with little aggregate, and is friable (easily loosened by tapping on it, or rubbing it with a crow bar, the answer is to do a replacement of at least that corner back to the right hand side of the open door on the edge of the right edge of the image. To do that will require require supporting the wooden structure on the inside with steel beams and lolly columns so all compression is off of the decomposed portion. Next operation would be to remove all the material that is now foundation. dig a trench 8 inches below local frost line, and avoid removing any material that will need to be replaced. This means that the bottom of the trench will be undisturbed soil. Form up to the bottom of the wood sill plates (repair wood as needed to create a solid connection), and put anchor bolts about every 36 inches hanging down into the forms at least 8 inches. Pour new stiff concrete into the forms and use a vibration stinger to assure complete filling and contact with the wood. With that cured and the weight put on it you have a real wall with real durability. Follow those same tactics on the lean to making it straight. Using 6 mill poly, cover the new concrete above intended grade and put a drainage tile (black slotted poly tube) to daylight down hill. Back fill the area with stone over the drain and a layer of gravel on that. I have experience with mortar like material that has had all the cement leached out of it. It cannot be made solid, and will not be reliable. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
