Posted by johnofnewhaven on September 03, 2023 at 05:30:55 from (174.202.64.128):
In Reply to: 1970 ford 8000 posted by Redneck911 on September 02, 2023 at 09:21:30:
My Ford 5000 had some water in the power steering fluid. I remove the canister off the power steering pump and dumped all the fluid out and changed the filter. I replaced the reservoir canister and then unhooked the return line to the pump. I just put the return line over a 5 gallon bucket. I had my son helping me and he would turn the steering wheel back and forth as I poured new fluid in the power steering reservoir. I did this until the power steering fluid ran clean. I then hooked the return line back up to the power steering pump. I again remove the power steering pump reservoir canister put another new filter in it and filled up the reservoir. It worked great. Not sure that's how you're supposed to do it but that's how I did it. My power steering fluid is actually automatic transmission fluid. I think it took me a couple gallons of running it through to flush it out good.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
