Posted by the tractor vet on September 07, 2023 at 09:16:06 from (108.220.145.239):
In Reply to: Cylinder Wall Scoring posted by farmallboy15 on September 07, 2023 at 03:16:53:
Well before ya get all carried away here and before ya end up costing your self more problems . First ya need to see how OUT OF ROUND the holes are and how much tapper and HOW MUCH WARE. Honing with a deglazing hone only follows the bore and will not correct and out of round or tapper , same goes for the ball hones . You set there with a deglazing hone you would be surprised just how much meat ya can remove and add to the already problem . When done ya can end up with piston slap and that leads to break skirts off the piston . Being just a two cylinder boring the block will make it ROUND again then the new oversize piston will fit like it should rings will seal like they should and compression will be back to where it should be and this will make starting easier . PLUS when done right it will live a long and happy life . Next thing i would do is have the injectors tested and the pump gone thru . Nothing will shorten the life then bad injectors and a pump over fueling.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
