Posted by ADB-Ia on September 10, 2023 at 11:43:10 from (167.142.114.46):
In Reply to: To35 posted by Waterbug on September 10, 2023 at 10:28:38:
Some armchair diagnosis. Several possibilities here. The cork or rubber gasket you mention is between the glass bowl and its base. From your post it doesn't sound like that is where your leak is. If it is leaking there, it is usually caused by a bad gasket or, if the gasket is good, by the base being distorted from over tightening the bowl clamp. It is easy to over tighten on the cheap replacement sediment bowls available today. If your leak is where the base threads into the tank, your pipe dope should have sealed that if it is properly threaded into the tank. It is possible that the pipe has a crack in it or the bung into the tank may have split causing it to leak. Another possibility is that the tank has developed pin holes in the sump from rust in the tank. One other possibility is if the assembly has a gas shutoff valve, it can leak from there. Many will have a packing nut there to tighten to keep it from leaking around the stem of the valve.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's The "Stuckest" You've Ever Been? - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I was about 14 (part of the problem) when I got stuck. I was disking with a cab equipped IH 966. The window was dirty and I was driving into the evening sun. It was hard to see and it was my first pass down the field. I got the tractor so stuck that the underside of the tractor was resting on the ground. My uncle wanted
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
