Posted by bwillett on September 12, 2023 at 08:53:30 from (172.79.230.129):
After the success of last years Plow Day, the association will hold another this year at our Vice President's farm this coming Saturday, September16th starting at 9 am with a rain date of Sept. 23rd. Because of the turnout lat year and how fast the 18 acres were plowed, We moved it to his farm, instead of using the field the association rents beside the site of our Show. We will have approximately 50 acres to plow this year.
The address of his farm is 21405 State Route 161, Milford Center, Ohio. There will be signs at the road.
Coming from Plain City, Ohio drive west approximately 9 miles. The farm is on the left, and the driveway is in a left hand curve. past Axlehandle Road and before Homer rd. Big square white farm house with a couple big pole barns. Coming from the west follow st. Rte. 4 to Irwin, Ohio and turn onto St. Rte. 161, drive approximately 3 miles, driveway is in the curve to the right. The farm will be on the right, past Homer road, and before Axehandle Road.
We had a 3 bottom plow limit last year, I don't think there is a limit this year.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
