Posted by caterpillar guy on September 19, 2023 at 05:21:04 from (47.26.14.222):
In Reply to: loaded tires posted by 300 dave on September 18, 2023 at 09:39:02:
I fill and empty loaded tires with no pump by putting the gizmo on the pipe coming out of the rim after stem is out then I use an old washing machine hose with both ends the same .Drin into barrel laying dwon using the top bung. when full get a second barrel. I also when done draining jack it up put a block under the center of the bottom of the tire let it back down gets most of the juice out that would be in the hollow of the rim. To fill if you have one of the following a loader a half barrel or a block and tackle just lift the filled barrel up so the fluid will flow from barrel into tire. IF no loader or block and takle I put the half barrel up on the fender then pour the fluid into the half barrel to let run back into the tire. We also removed the bleeder valve and put an old stem with a piece of shifter air line in it so the air can move both ways as you empty and fill. No pump used in the whole process. I have added air to the tire while draining to speed up process draining. Just push blow gun into end of washer hose to add a few pound of pressure. I also usually drain with a piece of radiator over flow hoes shoved on the pipe sized so it is tight enough to not leak.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.