Posted by Texasmark on September 22, 2023 at 06:55:53 from (147.160.220.76):
In Reply to: Re: Snake OIl? posted by Tony in SD on September 22, 2023 at 06:24:58:
One day I had nothing to do. Had an old 4 cycle push lawn mower and a 2 cycle weed eater that had been sitting for years. Wouldn't start. Gave them the SF treatment and got both running. I use it in everything except my tractors and I use Power Services products in the fuel. However several years ago I bought a 1988 Ford tractor that only had 900 hours.
Got it home and did the fluids change thing. Put in new oil and cranked it up and in a heartbeat the oil was turning black. Drained it and felt through the drain hole and had about 1/4 of sludge on the bottom of the pan......if you let dirty oil sit for an extended period, all the contaminants that were in suspension fall to the bottom....proved that looking at a clear plastic container I had sitting around for many years....bottom was black, oil had pretty much returned to honey color.
Anyway, I dumped in a 16 oz can of SF into the oil I drained out and put it all back in. Ran it for about 30 minutes at around 1000 RPM, shut it down, drained the oil (very black) and stuck my finger in the drain hole again....sludge gone. Put in fresh oil and filter and it stays clear initially like it should.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
