Posted by Pete in MD on September 30, 2023 at 08:06:17 from (100.16.164.26):
In Reply to: 1949 JD A seal for PTO posted by Hebrew62 on September 29, 2023 at 18:30:53:
The original seal was a 1/2'' wide double-lip seal which is no longer available. The replacement is a 1/4'' wide single-lip and you need 2 of them. I'm pretty sure 1 each of p/n AA2296R gets you 2 seals. When you install the seals make sure the garter springs are facing AWAY from each other. The inner seal keeps oil in the pump and the outer seal keeps air out of the pump. Put a dab of grease between the 2 seals. A substitute is Chicago Rawhide 13602 available from an auto parts store. Again, you need 2 of them.
If the old seal has cut a groove(s) in the pto shaft a Federal Mogul Redi-Sleeve #99138 will fix that problem.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
