PerryJosh64, I have commented before on this. My experience is with a LELY PTO Spinner. My take is that a fertilizer spreader will spread a certain VOLUME of product per a certain time depending on the setting. My spreader had a gate which opened to allow the product to pass. This was accomplished by 2 steel rings that rotated creating openings.
You need to determine the density of the product you desire to spread. My fertilizer dealer listed the density on the bill when I got a custom mix. Grain size does NOT give you any idea of what weight the fertilizer is per unit of volume. (e.g. Urea has large grains that are not very dense) I found density listed as pounds per cubic foot.
At first, I created a spread sheet with gate setting on one Axis and weight per acre on the other Axis. I had a nice line for each fertilizer type I spread. They were separate lines though. When I converted to VOLUME instead of weight, I had one line for all fertilizer types when I held the PTO speed and Ground speed and other variables constant.
In addition, you need to realize that the spreader pattern may change with lighter or denser product. Changes to PTO speed, Ground speed, Spacing, etc. will also change the amount of product spread per acre. HTH Keith Williams
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
