Posted by Majorman on November 16, 2023 at 08:17:25 from (86.190.123.219):
In Reply to: Re: Majorman controls posted by Janicholson on November 16, 2023 at 06:42:59:
This is what started my career in electronics way back in the early 1970's, a combine harvester forward speed control that adjusted forward speed around a set point based on engine and machine loading and the grain loss at the straw walkers, wind blast and sieve pan. Took it to Claas and spent five years developing it on their machines. It worked well but, at that time, operators did not like their machine being controlled by a green box in the corner of the cab.
Then I got into designing and building controls for other agricultural machines. This control panel from 2000 was used on a potato harvester. First time a touch control system had been used but all the buttons are membrane switches and control a thyristor based system to latch circuits on and off. Joysticks were used to control elevator functions and potentiometers to control web speeds.
This is another design from the early 2000's for a crop sprayer. The sprayer used three separate spray booms in one so that if different rates were required for, say, liquid fertiliser, all three could be switched on to increase the application rate, or switched off as required. Then there were the individual boom section controls. This again, used thyristor for switching and holding on valves as required from a push button controller on the hydrostatic drive controller, within reach of the drivers thumb. All this now is done with a chip today, but this system is repairable by, say a local TV or radio repair man who does not need special tools or programs. I do not think we ever had a failure on this control so it was pretty robust and many were sold.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
