You don't use it often and that's the problem. It's not meant to be stored indefinitely. Once glue has been exposed to air it starts curing and once that chemical reaction has started there's no stopping it. With ANY glue you have a limited time to use the contents of the bottle.
WHICH "Gorilla Glue" are you using? There is a polyurethane glue that needs moisture to activate. There is cyanoacrylate, aka "super glue." They also have PVA, aka "wood glue."
I assume you're complaining about the cyanoacrylate because that has the shortest shelf life once opened, and tends to plug up the tip worst, and because you said "a few drops." I built balsa model airplanes for years and I'm very familiar with the stuff. Stuck my fingers together on numerous occasions. Don't wipe the tip, because small fibers from the cloth stick to the tip and cause the glue to cure. I used to keep a bunch of extra tips soaking in acetone and swapped tips frequently.
If you only need a few drops you're best bet is to buy the little squeeze tubes instead of a great big bottle. Then you can use what you need and you're not wasting all that extra.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
