Posted by Texasmark on December 10, 2023 at 07:05:27 from (147.160.221.17):
In Reply to: Re: Wheel spacers posted by Tim in New York on December 10, 2023 at 05:27:34:
My smallest tractor is an LS M2-25 with FEL. I live on hilly terrain plus terraces and dams. For better stabilization I built a pair of 4 for the rear to help in stabilization. Inquired around the www and nothing to suit me were available....2 were. I chose 4 because one of the implements is a 5' shredder and 4 inches keeps the rear wheels within that cutting range.
Took a piece of 1/4 steel plate to a machine shop with the outline of the hub and bolt pattern on the rear wheel. Had 4 machined. Bought a piece of 8 diameter steel pipe and cut it off as specified. Welded it up and painted. Bought a set of bolts for the outsides and bolted it up. I have pictures of it but not that much to see....self explanatory herein.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.