Posted by Caryc on December 12, 2023 at 10:41:59 from (208.79.106.126):
In Reply to: Home Made Tractor posted by Majorman on December 11, 2023 at 23:34:44:
Quote: CVPost-bwillett (quoted from post at 08:41:52 12/12/23) One of my Uncles was a welder/general mechanic and had a tire recapper machine. I don't know how long it took him to build it, but back in the mid 1960's he built a tractor with a hit and miss engine on it with a 3 speed transmission and an automobile rear axle. He also built a cab for it. It resembled one of the big gas tractors of the early 30's. It was great fun to drive it around his property.....
There was an old guy in my area that had an old horse drawn road scraper / grader. He put an engine in the thing and he had two transmissions in the thing. One trans was for going forward and the other one was for going in reverse. It was a pretty neat thing. I wish I had taken a picture of it.
This post was edited by Caryc on 12/12/2023 at 10:43 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
