Posted by ford4wd08 on December 25, 2023 at 15:49:50 from (75.136.194.94):
Hi all, just bought IH 484 with a Dunham Lehr 22 loader with the single tilt cylinder.
It is currently setup with a universal pin on mount and an u bolted hay spear on it.
I was curious if anyone had one with a bucket on it and could take a couple of measurement for me. It looks like on the buckets I've seen online the tilt cylinder is offset and inch or two back towards the tractor from the bucket. Also it is a little lower than the arms I'm sure for leverage.
My setup works, but it doesn't have all the tilt im used to and I'm sure it's due to the cylinder pin on location. I've found some pictures online, but no measurements.
I see one company makes a pin on quick attach setup, but it's pricey. Might be able to modify mine some and potentially get a bucket for it. I just want a bucket for moving material mostly, not really any digging.
Any tips would be greatly appreciated.
EDIT: Also the distance from the arm pins to the tilt cylinder pins would be great too!
This post was edited by ford4wd08 on 12/25/2023 at 03:52 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.