Tractor Talk Discussion Board |
more electric fence
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEH on June 15, 2007 at 14:39:47 from (64.53.72.138):
Thanks for the helpful comments previously. I extended the fence to my garden and got some insulated wire for the gates. That wire is now on top of the ground temporarily. Fence charger is moved and I installed a new ground rod, 6 feet in the ground at the drip line of a building. Now, the fence charger has been clicking on the phone line and a better ground was supposed to stop that. Charger still clicks on the line. I cleared green vegetation away from the old part of the line and found a place where the electric fence was touching the barbed wire. Still clicking on phone. I have a Sears device to jump off dead batteries, pump air, it has a radio and a light. It also has a 110 volt outlet which I have used to power an electric drill. I plugged the fence charger into that and the clicking stopped. Does this mean that the houshold wireing does not have a good ground? Other reasons? The fence charger is a strong one good for 50 miles of fence which I don't have so I first thought that might be an issue. BTW, this is a procedure for putting the ground rod in without using a hammer. Take a gallon of water and wet the ground. Take ground rod in both handsand state driving it into the ground, of course removing the rod with each stroke. Pour some more water in the hole you have started. Repeat until rod is deep enough. If you hit a rock, move over and try again. Worked fine in this red clay. Learned this from one of my ham radio friends. Probably old news to some of you, but I was impressed when I first tried it. KEH
Replies:
Home
| Forums
Today's Featured Article -
A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|