Tractor Talk Discussion Board |
Re: Yesterday's Barn
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Grumbine on February 21, 2002 at 04:26:25 from (208.137.243.161):
In Reply to: Yesterday's Barn posted by Bill Grumbine on February 20, 2002 at 14:08:53:
Good morning men Thanks for the responses. Roger, my first thought was just what you wrote. Unfortunately, the tractor is parked inside, facing the wrong way. Mark, I couldn't get ten people together either, not without a month's notice. Lifting the door won't be hard, with a lever and a fulcrum. It only has to move about 3" vertically. RWK, the way the door hangs, there is no place to attach anything higher up where it would be able to move the door. Besides, I'm a ground level kind of guy. I don't mind heights, but I do mind ladders. I am 6'2" and 360 lbs. There aren't too many ladders made for people like me. On the other hand, I can replace three of Tom's ten guys all by myself. ;-) Old Bones, you have described the rollers exactly. I would like to avoid having to remove the door if at all possible. To do so would require removing the door next to it and sliding it a good 20' or better. There are four doors on one long track. Dontcha know, it is the inside hanger on one of the inside doors that has come off. Tom, the roller doesn't need to come off the track, but I might be able to get the bracket off the door. That would allow me to reattach it to the roller, and the I would (should) have clearance to get to the bolts holding the bracket to the door. That is probably the least onerous of the possibilities at hand. Of course, I am going to have to remove about 17 layers of paint from the threads of the bolts to get them to turn. I didn't have anything else to do today anyway... Bill
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|